The manufacturer of insulating rubber pad explains the procedure flow of laying insulating rubber board in high and low voltage distribution room

The manufacturer of insulating rubber mat emphasized that there is no procedure flow for laying insulating rubber board in high and low voltage distribution room. However, according to some internal requirements of "electrical safety work regulations" (part of electrical equipment of distribution station and power station), many electrical equipment must stand on the insulating rubber plate. For example:
1. To solve the problem of high voltage fuse (commercial insurance), it is necessary to wear protective glasses and insulating rubber gloves. If necessary, it is necessary to use insulating clip and stand on the insulating rubber plate or insulating table.
2. When adjusting the   cleaner and electric slip ring on the rotating motor, it should be carried out by experienced welders and follow the following requirements. When working, the insulating rubber pad has: (the insulating rubber plate is a fixed insulating pad) do not touch two sides or one pole and part of the grounding device, and do not work separately.
3. When working on the circuit of rotating rotor resistor, extend the motor carbon brush or remove the resistor completely. Wear rubber gloves or special tools with insulating rocker, wear insulating boots or stand on insulating board.
4. When working on the second control circuit of relay protection device, instrument and equipment, it must be maintained by full-time personnel, use special insulation tools, and stand on the insulation board.
5. The high pressure test engineer should pay attention to the whole process of charging, do not have to chat with others, warn the abnormal situation anytime and anywhere, and the actual operation staff should stand on the insulation mat.
For convenience, manufacturers of insulating rubber mats must often lay insulating rubber sheets and replace them with long-term ones when necessary.